Installation
Instructions
INSTALLING
THE CHARCOAL FILTER
_!] Remove 2 screws on top of microwave
oven,just
above the grille panel, using a Phillips screwdriver,
If two screws are not accessible,
see section A5,
_]
Open the door,
_]
Remove the grille,
1
|
[_
Insert the top of the filter up and into the grooves on
both sides of the inside of the top opening, Once you
have cleared the bottom tab, push the bottom of the
filter in until it rests in place behind the tab,
Grooves
in
Filter (dashed
to show
Microwave
for
[]
Replace the grille by inserting the top grill flange
into the slots in the case as shown,
_]
Replace the 2 top screws,
[_
Close the door,
insure bottom
tabs are seated
as shown.
r_
MOUNT THE MICROWAVE OVEN
_.t.ul,u,_:
To evo_d
the r_sk of p ersonel
injury (beck injury
or other injuries
due to excessive
weight
of the microwave}
or property
damage,
you
will need two people to install
this microwave.
IMPORTANT: Do not grip or use handle during
installation,
WA RNING: Risk of E lectric
Shock.
Can
cause injury
or death:
If installing
unit with metal
countertops,
cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening
screws,
NOTE: When mounting
the microwave,
thread power
cord through
hole in bottom
of top cabinet, Keep it
tight throughout
Steps 1-3, Do not pinch cord or lift
microwave
oven by pulling cord,
_i]
Lift microwave,
tilt it forward,
and hook slots at
back bottom
edge onto four lower tabs of mounting
plate,
Power Cord
[]Rotate
front of microwave
oven up against
cabinet
bottom,
15