Qilive Q.5476 Manual De Instrucciones página 8

To adjust the suction tube, pull back and hold the release switch on the outer section of the tube
•
EN
and pull or push the inner section at the same time.
4.4. CONNECTING THE SUCTION TUBE TO THE FLOORHEAD
Push the open end of the suction tube into the floorhead and turn it clockwise or anticlockwise
•
until it clicks into position.
If you want to separate the two pieces, press and hold the release button on the floorhead and
•
pull out the suction tube at the same time.
4.5. ADJUSTING THE FLOORHEAD
You can adjust the floorhead to clean carpets, rugs and robust hard
floors. Note: Please follow the flooring manufacturer's cleaning and care
instructions to avoid damaging the flooring.
To clean even hard floors which are not susceptible to scratching,
•
as well as flooring with gaps or deep crevices in it with the brush
protruding, press the rear footswitch (
To vacuum carpets and rugs with the brush retracted, press the front
•
footswitch (
4.6. USING DEEP CLEAN AND EASY CLEAN MODES
The floorhead allows you to switch between Deep Clean and Easy Clean modes. Deep Clean mode
provides maximum suction and is ideal for usage on carpets on a regular
basis. However, due to the maximum suction, it may take more effort to
move the floorhead across the surface being cleaned. For more frequent
cleaning, you may use Easy Clean mode, which offers greater comfort and
ease of cleaning.
Tip: Use Easy Clean mode for daily cleaning. Use Deep Clean mode two
or three times a month for deep cleaning of carpets, giving them extra life
and shine.
To switch between Easy Clean and Deep Clean modes, lift the
•
floorhead and then move the bar on the floorhead towards the back
or front of the floorhead.
5. USING THE PRODUCT
5.1. TURNING THE APPLIANCE ON/OFF
1. Hold the power plug and pull the power cable out to the required length. Note: A yellow mark
on the power cable indicates the ideal cable length. Do not extend the power cable beyond
the red mark.
2. Insert the power plug into an electrical socket.
3. Press the On/Off footswitch (
5.2. REWINDING THE POWER CABLE
1. Press the On/Off footswitch (
2. Pull the power plug out of the electrical socket.
3. To rewind the power cable, press the rewind footswitch (
the power cable with the other hand to ensure that it does not whip.
5.3. ADJUSTING THE SUCTION POWER
Once turned on, the appliance starts operating using the maximum suction power. You can adjust
the suction power to suit the type of surface being cleaned. Reducing the suction power reduces the
amount of effort required to move the floorhead or nozzle.
The symbols between the suction power buttons indicate the types of surfaces the power levels
are suitable for.
) on the floorhead.
) to turn the appliance on or off.
) to turn off the appliance.
) on the floorhead.
) with one hand (or foot) and guide
8