Triton TRA001 Instrucciones De Uso Y De Seguridad página 15

Accessories
A wide range of suitable accessories for this tool are available from
your Triton stockist, including a large selection of
cutter/router bits. Spares including carbon brushes, guide bushes
and collets are available from your Triton stockist or
www.toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the mains power supply,
before carrying out any maintenance/cleaning of the charger.
General Inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage
or wear. Repairs should be carried out by an authorised Triton
service centre. This advice also applies to extension cords used
with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye
protection and gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause
internal parts to wear quickly, and shorten the device's service
life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning
is not sufficient, a mild detergent on a damp cloth is
recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the
ventilation holes (where applicable)
Lubrication
• Slightly lubricate all moving parts at regular intervals with a
suitable spray lubricant
Brushes
• Over time the carbon brushes inside the Motor (6) may become
worn
• Excessively worn brushes may cause loss of power, intermittent
failure, or visible sparking
• To replace the brushes, remove the two Brush Access Covers (9).
Carefully remove the worn brushes (Image R) and ensure the
sockets are clean. Carefully replace with new brushes and then
replace the Brush Access Covers
• After fitting run the router without load for 2-3 minutes to help
the brushes bed in. The process of the brushes fully bedding
in may take repeated uses. Motor sparking may continue until
new carbon brushes have bedded in
• Alternatively, have the machine serviced at an authorised service
centre
Contact
For technical or repair service advice, please contact the
helpline on (+44) 1935 382 222
Web: www.tritontools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301 LJ Zaltbommel
The Netherlands
Storage
• Store this tool carefully in a secure, dry place out of the reach
of children
Disposal
Always adhere to national regulations when disposing of power
tools that are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and
electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on
the correct way to dispose of power tools
EN
15