Triton TRA001 Instrucciones De Uso Y De Seguridad página 16

Troubleshooting
Problem
No function when
On/Off Power Switch (8)
is operated
Inaccurate cutting profile
Router will not operate
Router runs or cuts slowly
Excessive vibration
Heavy sparking occurs
inside motor housing
Micro Winder (20) "clicks"
or not adjusting
Makes an unusual sound
EN
16
Possible cause
No power
Defective On/Off Power Switch
Depth Stop (3)
not correctly adjusted
Incorrectly fitted or loose router
bit/Collet (24)
No supply of power
Brushes worn or sticking
Switch is faulty
Motor components faulty or
short circuited
Blunt or damaged cutter
Speed Controller (10) set low
Motor is overloaded
Incorrectly fitted or
loose router bit
Bent or damaged router bit
Brushes not moving freely
Damaged or worn motor
Plunge Lock Lever (11) engaged
Reached end of
adjustment range
Mechanical obstruction
Damage to internal windings
Check power supply
Replace the On/Off Power Switch at an authorised Triton service centre
Ensure that the Depth Stop corresponds to the maximum amount of cut
permitted by the Turret Stops (1)
Tighten router bit/Collet and cutter assembly
Check that power is available at source
Disconnect power, open Brush Access Covers (9)
and ensure brushes are not damaged or heavily worn
Have the tool serviced by an authorised Triton service centre
Re-sharpen or replace cutter
Increase variable speed setting
Reduce pushing force on router
Refit or tighten router bit
Replace router biwt
Disconnect power, remove brushes, clean or replace
Have the tool serviced by an authorised Triton service centre
Release Plunge Lock Lever
Reset the Micro Winder and set depth with the Depth Stop (3)
Have the tool serviced by an authorised Triton service centre
Solution