OHAUS Ranger 2000 Serie Manual De Instrucciones página 25

Ranger™ 2000 Series
4.8 Print Menu
Enter this menu to set printing parameters.
Reset:
Stable Only:
Auto Print:
Content:
Layout:
Data Transfer: off, on
End Print:
Reset [reset]
Reset the Print menu to factory defaults.
NO = no reset
YES = reset
Stable Only [Stable]
Set the printing criteria.
OFF = values are printed immediately
ON = values are only printed when the stability criteria are met.
Auto Print [A.Print]
Set the automatic printing functionality.
OFF = disabled
ON.STAB = printing occurs each time the stability criteria are met.
INTER = printing occurs at the defined interval
ACCEPT = printing occurs each time the display is within the Checkweigh
CONT = printing occurs continuously
When ON.STAB is selected, set the condition for printing, where:
LOAD = printing occurs when the load is stable and greater than zero
LOAD.ZR = printing occurs when any load is stable and equal to or greater
When INTER is selected, set the Print Interval.
1 to 3600 (seconds)
no, yes
off, on
off, on stable, interval, continuous, accept
Result (-> off, on)
Gross (-> off, on)
Net (-> off, on)
Tare (-> off, on)
Header (-> off, on)
Footer (-> off, on)
Mode (-> off, on)
Unit (-> off, on)
Info (-> off, on)
Accu (-> off, result, all)
Format (->S,M)
Feed (-> Line, 4 Lines, form)
Exit menu
accept range and stability criteria are met.
than zero.
EN-23