Edesa EFS-0411 WH/A Manual De Instrucciones página 22

2.6 Levelling feet
Schematic diagram of the leveling feet
L
H
(The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor)
Adjusting procedures:
a. Turn the feet clockwise to raise the refrigerator;
b. Turn the feet counterclockwise to lower the refrigerator;
c. Adjust the right and left feet based on the procedures above to a horizontal level.
2.7 Installation of door handle
Handle base
1
2 Reserved hole on the door
3 Screwdriver
Instruction for handle installation:
1. As shown in the figure, align the two round holes inside the handle base ( 1 )
with the reserved holes on the door ( 2 ), and use the self-contained Phillips
screwdriver ( 3 ) to fasten the two hexagon screws ( 4 ) until the handle
base ( 1 ) does not shake.
2. Align the handle ( 5 ) with the upper and lower guide slots on the handle
base ( 1 ), and push the handle horizontally from left to right as shown in
the figure until it reaches the end.
3. Align the countersunk screw 6 with the reserved hole on the lower side of
the handle ( 5 ) , and secure it tightly.
Note:
6 To remove the handle, you need to remove the screw 6 first, and then
slightly shake the handle to push it out in the opposite direction (from right to
left). Be careful not to push it hard horizontally to avoid hitting your fingers.
(optional)
2
1
4
3
5
6
M5 hexagon screw (two)
4
5 Handle
6
M5 countersunk screw (one)
20