GRAPHITE 58G227 Instrucciones De Uso página 21

●
Put an Allen key in the chuck and gently tap the other end of the key.
●
Unscrew the chuck.
●
In order to install the chuck, perform the above actions in a reverse order.
Any and all defects must be removed by service companies authorized by the manufacturer.
RATING DATA
Parameter
Battery voltage
Battery type
Battery capacity
Range of rotational speed in the idle gear
Range of chuck
Range of torque control
Maximum torque
Protection class
Weight
Year of manufacture
Parameter
Supply voltage
Supply current frequency
Charging voltage
Max. charging current
Charging time
Protection class
Weight
Year of manufacture
NOISE AND VIBRATIONS DATA
Information on noise and vibrations
The emitted noise levels, such as the level of emitted acoustic pressure Lp
Lw , and the measurement uncertainty K are given below in the instruction in accordance with the EN
A
60745 standard.
The vibration values a and the measurement uncertainty K, determined in accordance with the EN 60745
h
standard, are given below.
The vibration level given below in this instruction was measured in accordance with a measurement
procedure set forth in the EN 60745 standard and can be used for comparing power tools. It can also be
used for preliminary evaluation of exposure to vibrations.
The vibration level given here is representative for the basic uses of the power tool. If the power tool is
used for other purposes or with other bits, or if the power tool is not maintained properly, the vibration
level may change. Also, these conditions may also result in an increased exposure to vibrations during the
entire work period.
In order to accurately estimate exposure to vibrations, one must consider periods when the power tool
is switched off or when it is switched on and not used for work. This way, the total exposure to vibrations
may turn out to be much lower. One must implement additional safety measures in order to protect the
TECHNICAL PARAMETERS
Cordless drill/driver
Charger
21
Value
18 V DC
Li-Ion
2000 mAh
0-400/0-1100 min
-1
1-13 mm
1-20 plus drilling
42 Nm
III
1,56 kg
2015
Value
230 V AC
50 Hz
21 V DC
2500 mA
1 h
II
0,58 kg
2015
and the level of acoustic power
A