Verona ROMEO 207659 Manual Del Usuario página 8

button 5 will light up and all others will turn off.
GB
• After preparing the required amount of coffee, press any of
the buttons (fig. 3/pos. 1-4) to stop the programming of the
beverage. The preset button LED will turn off. The button LED
5 will flash and the other LEDs will be solid.
• Repeat the above steps for all the buttons you want to pro-
gram.
Models 207598, 207642, 207659
Automatic models allow you to program each portion of the
drink.
• Place the measured portion of coffee in the coffee strainer
and fix the portafilter in the group.
• Press and hold the programming button (fig. 3/pos. 5) for 3
seconds. The LED of button 4 (fig. 3/pos. 4) starts flashing.
When all LEDs on the keypad light up, you can start program-
ming using the keypad.
• Within 5 seconds, press the portion button (fig. 3/pos. 1-4) you
want to program. The LED of the selected button and button 5
will be on while the others will be off.
• After preparing the appropriate amount of coffee, press but-
ton 5 to stop dispensing. The LED of the selected portion will
turn off, the LED of button 5 will start flashing and the other
LEDs will be on.
• Repeat the above steps for all the buttons you want to pro-
gram. If no option is selected within 20 seconds, the timeout
alarm will sound and the device will exit programming mode.
Espresso preparation
Preliminaries
• Place a measured portion of freshly ground coffee (6,5-7g per
espresso) in the strainer.
• Press down the ground coffee with the coffee tamper to dis-
tribute the ground coffee evenly in the portafilter.
• Place the stock in the group by turning it clockwise in the
group slot.
• The stock is properly attached when it locks into the socket.
• Place a cup (or two, depending on the portafilter) under the
outlet of the portafilter.
Automatic portion
• On the keypad located above the group in use, press the but-
ton of the selected portion of coffee - the drink will be poured
into the cup.
• The appliance will automatically turn off the group after
brewing a certain amount of coffee.
Manual portion selection (method 1)
• To start brewing coffee, press button 5.
• To stop brewing coffee, press button 5 again.
Manual portion selection (method 2)
• To start brewing coffee, press the button above the group.
• To stop brewing coffee, press the button above the group
again.
Adjusting the thickness of ground grains.
• To prepare a good espresso (approx. 30 ml), the ground cof-
8
fee should have a certain thickness. The dosing time depends
on the thickness of the ground beans, and thus the grinding
thickness is important for the quality of the prepared bev-
erage.
• The ideal dispensing time is 18-20 seconds.
• If the dispensing time is longer than 20-25 seconds, the cof-
fee should be ground coarser.
• If the dispensing time is less than 18 seconds, the coffee
should be ground finer.
Hot water dispensing
• To pour hot water, turn the water valve (fig. 1/pos. 12, fig. 2/
pos. 10) located above the tap clockwise. Hot water will be
dispensed from the tap. Turn the valve to the left to shut off
the water flow.
Steam dispensing
• To dispense steam, turn the steam valve (fig. 1-2/pos. 3)
above the nozzle clockwise. Steam will then come out of the
nozzle. To stop dispensing steam, turn the steam valve to the
left.
• Before and after using the steam lever to froth milk, open the
steam lever for 1-2 seconds to remove any impurities. Clean
the nozzle with a wet cloth after each use.
• Remember never to put your hands under the steam outlet!
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & main-
tenance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
Models 207499, 207581
Daily cleaning
Cleaning the group
• Automatic models have an automatic cleaning program.
• Place the sieve supplied with the appliance in the portafilter.
• Place the portafilter in the group you want to clean.
• Simultaneously press buttons 1 and 5 to start the cleaning
process. During cleaning, the LEDs of both buttons flash.
• When cleaning is complete, the LEDs will turn off. The ap-
pliance will automatically switch to normal operating mode.
• Remove the strainer from the portafilter.
• Run water through the group 2-3 times to rinse it. It is pos-
sible to run the cleaning process for several groups at the
same time.