Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the strainers and portafilters (includes 207598,
207642, 207659)
• Mix the espresso machine cleaner with hot water and im-
merse the strainers and portafilters
Cleaning the appliance (includes 207598, 207642, 207659)
• Clean the portafilter holder and group with a damp cloth.
• Thoroughly clean the faucets and nozzles to avoid sediment.
Weekly cleaning
Cleaning the group
• Place the sieve supplied with the appliance in the portafilter.
• Pour a tablespoon of detergent intended for cleaning coffee
machines into the portafilter.
• Place the portafilter in the group you want to clean.
• Simultaneously press buttons 1 and 5 to start the cleaning
process. During cleaning the LEDs of both buttons flash.
• When cleaning is complete, the LEDs will turn off. The device
will automatically switch to normal operating mode.
• Remove the strainer from the portafilter.
Cleaning coasters and trays (includes 207598, 207642,
207659)
• Remove the plastic grids on the cup warmer and the metal
tray grid under the groups.
• Remove the tray under the group.
• Clean the grids and trays with a damp cloth and a small
amount of detergent for washing machines.
Cleaning the grounds container (includes 207598, 207642,
207659)
• After removing the tray located under the group, you will gain
access to the grounds container. Clean the tank with a brush.
Make sure the drain is not blocked by coffee grounds.
Cleaning the appliance (includes 207598, 207642, 207659)
• Clean the water filter regularly (at least once every two
weeks) by following the instructions that come with it.
Models 207598, 207642, 207659
Weekly cleaning
Cleaning the group - automatic models
• Place the sieve supplied with the appliance in the portafilter.
• Place the portafilter in the group you want to clean.
• With the appliance turned off, press the power button and
button 3 at the same time to turn it on. This button configura-
tion will start the cleaning process. During cleaning the LEDs
of both buttons flash.
• When cleaning is complete, the LEDs will turn off and the
device will automatically switch to normal operating mode.
• Remove the strainer from the portafilter.
• Run water through the group 2-3 times to rinse it.
Cleaning the group- semi-automatic models
• Place the supplied blind sieve in the portafilter.
• Place the portafilter in the group you want to clean.
• Press the button above the group you want to clean to activate
its cleaning process.
• Press the button above this group again to stop cleaning.
• Repeat the above steps until the water coming out of the
group is completely clean and free of detergent.
• Remove the blind strainer and fit the normal one back into
the portafilter. Place the portafilter in the group.
• Run water through the group 2-3 times to rinse it.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
Possible cause
There is no water
in appliance's tank,
All LEDs are flick-
and the automatic
ering.
volume meter failed
to refill it within 120
seconds.
Beverage prepara-
The LED of the se-
tion time exceeded
lected
beverage
the standard 5 sec-
button is flickering.
onds.
All LEDs are flick-
ering and the appli-
The probe measur-
ance is locked.
ing water level de-
tected not enough
The
appliance
water inside the
stopped dosing a
boiler.
beverage and all
LEDs started flick-
ering.
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
GB
Possible solution
Turn the appliance
OFF and ON again.
Select any other
beverage to stop the
flickering.
Refill the boiler with
water.
9
Publicidad
