Angelo Po 0N1FR1ED Manual De Uso página 46

ENGLISH
Proceed as follows.
- Press the key (B) to stop the cooking cycle
1)
and deactivate the appliance. The light (P)
comes on.
Press the key (D). The value of the hours on
2)
the display (A) will start to fl ash.
Press one of the keys (F-G) increase or de-
3)
crease the value, until the required value is
obtained.
Press the key (D) save the new value displayed.
4)
The value of the minutes on the display (A)
will start to fl ash.
Press one of the keys (F-G) to increase or de-
5)
crease the value, until the required value is
obtained.
Press the key (D) to save the new value dis-
6)
played. After a few seconds the appliance
switches to stand-by mode.
This procedure is used to set a temperature
threshold at which a buzzer is triggered.
Proceed as follows.
Press the key (C) to start the oil heating phase
1)
and the display (A) will show the cooking
temperature.
Press the keys (F-G) to increase or decrease
2)
the values shown on the display (30÷190°C).
Wait about 4 seconds for the new value set
3)
to be saved.
Press the keys (F-G) together and the display
4)
(A) will show the oil temperature in the
cooking well.
NOTE: During the cooking cycle the
value shown on the display (A) fl ashes if the
temperature of the oil in the well is less than
that set, or remains constantly on if the tem-
perature is at or above the set level.
18
CURRENT TIME SETTING
COOKING TEMPERATURE SETTING
USE AND OPERATION
B
P
C F
A
C F
A
G D
G
3301300_ut_GB_rev.2