Publicidad
Step 18
1
D14
Q
Groove
Insert the LARGE DRAWER SIDES (D14 and D15) at an
å
angle into the slot at each end of the LARGE
DRAWER FRONT (Q).
3
Fasten the LARGE DRAWER BACK (D104) to the LARGE DRAWER SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D701) inserts into the groove of the LARGE DRAWER BACK (D104).
å
Repeat this step for the other drawers. Use the SMALL DRAWER FRONT (S), SMALL DRAWER SIDES (D83 and D84),
å
SMALL DRAWER BACK (D103), and SMALL DRAWER BOTTOM (D714) for the small drawer. Use the DRAWER FRONT (R),
DRAWER SIDES (D30 and D31), DRAWER BACK (D82), and LARGE DRAWER BOTTOM (D701) for the other drawer.
Page 22
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D104
D14
D701
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D701) into the
å
grooves in the LARGE DRAWER SIDES (D14 and D15) and
LARGE DRAWER FRONT (Q).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
414783
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
fi n
i s h
r f a
e d
c e
D701
D15
Q
30S
(12 used in this step)
www.sauder.com/services
Publicidad
