Publicidad
Idiomas disponibles
Idiomas disponibles
3. Make sure garden hose is connected to water inlet. Check
that high pressure hose is connected to spray gun and high
pressure outlet. Turn on water.
NOTICE You must attach all hoses before you start the pressure
washer.
4. Start the pressure washer as instructed in Start Pressure
Washer.
5. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
6. Allow detergent to "soak in" for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from drying.
To prevent streaking, Do Not allow detergent to dry on surface.
Rinsing
1. Remove foam tip from wand, install another tip.
2. Keep spray gun a safe distance from area you plan to spray.
WARNING Risk of kickback.
Spray gun could kickback causing you to fall
resulting in death or serious injury.
• Operate the electric pressure washer from a stable surface.
• Never use from a ladder, scaffolding, or any other similar
location.
• Firmly grasp spray gun with both hands when using power
spray modes to avoid injury when spray gun kicks back
3. Apply a high pressure spray to a small area and then check
surface for damage. If no damage is found, you can assume
it is okay to continue rinsing.
4. Start at top of area to be rinsed, working down with same
overlapping strokes as you used for cleaning.
Other Cleaning Tips
• NEVER leave the electric pressure washer unattended while
it is plugged into an electrical outlet and while water is
supplied to the equipment.
• If you have the nozzle too far away from the surface being
washed, the cleaning may not be as effective.
How to Store Accessories
The unit is equipped with areas to store your high pressure hose,
spray gun, spray wand, and power cord. Coil power cord on
hook on back of the unit. Wrap high pressure hose and store
on hook on back of the unit. Store spray gun in slots on left
side of main unit. Snap spray wand in slots on right side of
main unit.
NOTICE Flush detergent and siphoning system after each use by
placing tube into a bucket of clean water, then run pressure
washer with soap tip for 1-2 minutes.
Maintenance
General Recommendations
Regular maintenance will improve the performance and extend
the life of the electric pressure washer.
The electric pressure washer's warranty does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, the operator must maintain
the electric pressure washer as instructed in this manual,
including proper storage.
NOTICE Should you have questions about replacing components
on your electric pressure washer, please call customer center for
assistance.
Before Each Use
1. Clean debris.
2. Check water inlet screen for debris or damage.
3. Check high pressure hose for leaks.
4. Check spray gun operation.
Electric Pressure Washer Maintenance
Clean Debris
Daily or before use, clean accumulated debris from electric
pressure washer. Inspect cooling air slots and openings on the
main unit. These openings must be kept clean and unobstructed.
The electric pressure washer parts should be kept clean to reduce
the risk of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
NOTICE Improper treatment of the electric pressure washer can
damage it and/or shorten its life.
• DO NOT insert any objects through cooling slots.
Check and Clean Water Inlet Screen
Remove water inlet coupling (D).
Water inlet is located at bottom of unit. Examine water inlet
screen. If the screen is dirty, clean with a small brush and water.
If the screen is damaged, replace it.
16
Publicidad
