LawnMaster CLMF4841E Manual De Instrucciones página 29

TROUBLESHOOTING
WARNING
Gloves and appropriate protective clothing must be worn when performing these instructions.
Always turn off the machine and remove the battery pack and isolator key before making any
PROBLEM
Mower fails to start.
The motor stops.
The mower cuts grass unevenly
or motor labours.
POSSIBLE CAUSE
The isolator key is not installed
correctly/fully.
The batteries are not installed
correctly.
The batteries are not fully
charged.
Possible clogging.
The grass is too long.
The batteries are defective.
Defective switch lever or safety
button.
The mower is blocked by
Motor protection has engaged
due to overheating.
The lawn is rough or uneven or
cutting height not set properly.
The blade is blunt.
The blade area is blocked.
The blade is assembled
incorrectly.
29
SOLUTION
Install the isolator key correctly.
Ensure the batteries are
correctly installed.
Charge the batteries.
Remove the isolator key and
batteries. Check underneath the
mower and clear as necessary
(always wear gardening
gloves).
Set a higher cutting height.
Replace the batteries.
Allow the mower to cool down.
Cut long grass down in stages
and avoid overloading the
motor.
height best suited for your lawn.
Replace the blade.
Clean the blade area and
remove the blockage.
Install the blade correctly. Blade
wings should be facing up away
from the ground.