LawnMaster CLMF4841E Manual De Instrucciones página 30

TROUBLESHOOTING
Mower does not mulch properly.
Poor collection performance.
Area of cut (battery duration) is
not large enough.
The blade fails to rotate.
Excessive vibrations/noise.
possible.
The charge control LEDs do not
light up after inserting the mains
plug into the socket.
Wet grass clippings are sticking
to the underside of the deck.
Missing mulching plug.
The mowing conditions are not
optimal.
Mulching plug is inside
collection chute.
Height of cut is too low.
The grass is too high.
The grass is wet or damp.
The grass is dense.
The blade is blocked by grass.
The blade nut/bolt is loose.
The blade nut/bolt is loose.
The blade is damaged.
The motor shaft is bent.
The battery contacts are
contaminated.
Socket outlet, fuse, mains cable
or battery charger are defective.
The battery has a fault.
Mains plug of the battery
charger is not plugged in
properly.
Socket outlet, mains cable or
battery charger are defective.
30
Wait until the grass dries before
mowing.
Install the mulching plug.
Cut long grass down in stages
by gradually lowering the height
of cut. Wait for wet grass to dry.
Remove the mulching plug.
Increase the height of cut and
walk slower.
Increase the height of cut and
walk slower.
Wait until the grass is dry and
walk slower.
Increase the height of cut, walk
slower and cut more frequently.
Switch off the mower and
remove the grass (always wear
gardening gloves).
Tighten the blade nut/bolt (25
Tighten the blade nut/bolt (25
Replace the blade.
Stop the mower and remove
the isolator key and batteries,
and inspect for damage. Have
person.
Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or replace
the battery.
Check the mains voltage and
fuse, if necessary, contact
aftersales helpline.
Replace the battery.
Insert mains plug fully into the
socket outlet.
Check the mains voltage and
if necessary, contact aftersales
helpline.