Publicidad
Idiomas disponibles
Idiomas disponibles
8.2.1
Connecting the suction adapter (11)
and the angle adapter (10)
1. Place the suction adapter (11) on the bottom of the
product.
2. Align the connection screw (12) with the connection
(6).
3. Hold the product by the handle (3). Turn the product
by 90º.
4. Use a Phillips screwdriver (not included in the
scope of delivery) to turn the connection screw (12)
clockwise until it is tight.
5. Push the angle adapter (10) onto the suction adapt-
er (11) until the suction adapter (11) is connected
tightly to the angle adapter (10).
8.3
Selecting a tool attachment
The following tool attachments are only the most common types. You can obtain information regarding further tool at-
tachments from specialist retailers if required.
HCS plunge cut
saw blade (14)
Materials:
• Wood
• Plastic
• Plaster
• Laminate
• Other soft materials
Usage:
• Separating cuts
• Plunge cuts
• Sawing close to the edge and in
places that are difficult to access
Example:
• Cutting recesses in plasterboard walls Example:
Diamond saw
blade (15)
Materials:
• Tile adhesive
• Grouting
Usage:
• Removing material residues
Example:
• Removing tile adhesive when replacing
damaged tiles
• Milling out grout on wall and floor tiles
8.4
Inserting/removing the tool
attachment (Fig. 5)
WARNING
Tool attachments may be sharp and become hot
during use. Always wear protective gloves when han-
dling the tool attachments.
6. You can align the angle adapter (10) in various di-
rections in order to adjust it to different working con-
ditions.
8.2.2
1. Remove the angle adapter (10) from the suction
adapter (11).
2. Hold the product by the handle (3). Turn the product
by 90º.
3. Use a Phillips screwdriver (not included in the
scope of delivery) to turn the connection screw (12)
anticlockwise until it is completely loose.
4. Remove the suction adapter (11) from the product.
Scraper (16)
Materials:
Usage:
Sanding sheets
(17)
Materials:
Usage:
CAUTION
Keep your hands away from the tool attachment
when the product is in operation.
Note:
If you would like to use the dust extraction unit, you
must connect it prior to installing the tool attachment
(see Connecting/removing the suction adapter (11) and
the angle adapter (10) (fig. 4))
See also
www.scheppach.com
Removing the suction adapter (11)
and the angle adapter (10)
• Mortar/concrete residues
• Tile/carpet adhesive
• Paint/silicone residues
• Removing material residues
• Removing carpet adhesive resi-
dues from the floor
• Wood and metal
• Sanding edges
• Sanding in places that are diffi-
cult to access such as corners
GB | 25
Publicidad
