Publicidad
Idiomas disponibles
Idiomas disponibles
10 Operation
The battery-powered lawnmower has a cutting tool that
rotates parallel to the cutting plane. It is equipped with a
powerful and quiet-running electric motor, a robust
housing, a safety bar, a safety key, a double-sided lawn
edge intake and a grass collection bag. The product's
height can also be adjusted to 6 positions and has
smooth-running wheels. Please refer to the following
descriptions for the function of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
10.1
Mowing with the grass collection
basket
ATTENTION
Do not operate the product without the grass collec-
tion basket fully attached or without a mulching insert.
ATTENTION
Only remove or attach the grass collection basket
when the engine is switched off and the blade is sta-
tionary.
10.1.1
Inserting the grass collection
basket (5) (Fig. 9, 13)
1. Lift the discharge flap (8).
2. Lift the grass collection basket (5) by the carrying
handle (5a).
3. Hang the grass collection basket (5) in the grass
collection basket suspension provided at the rear of
the product.
4. Put down the discharge flap (8), it holds the grass
collection basket (5) in position.
10.1.2
The air flow generated by the blade lifts the level indica-
tor. When the grass collection basket is full, the air flow
stops. If the air flow is too low, the level indicator clos-
es. This is a note to empty the grass collection basket.
The unrestricted function of the level indicator is only
assured with optimum air flow. External influences such
as wet, dense or high grass, low cutting levels, dirt or
similar can affect the air flow and the function of the lev-
el indicator.
• Flap open: Grass collection basket is being filled
• Flap closed: Grass collection basket is full
10.1.3
WARNING
Before removing the grass collection basket,
switch off the engine and wait for the blade to
stop.
ATTENTION
Danger of injury!
Remove the grass collection basket only when the
engine is switched off and the blade is stationary.
The grass collection basket must be emptied as soon
as grass cuttings are left lying behind on the ground
during mowing.
1. To remove the grass collection basket (5), lift the
discharge flap (8).
2. Take out the grass collection basket (5) by the car-
rying handle (5a). In accordance with the safety reg-
ulations, the discharge flap (8) closes when the
grass collection basket (5) is unhooked and closes
the ejection opening.
If grass cuttings remain in the opening, it is advisable to
pull the lawnmower back about 1 m to make it easier to
start the motor.
ATTENTION
Do not remove cuttings in the mower housing and on
the working tool by hand or with your feet, but with
suitable aids, e.g. brush or hand brush.
To ensure good collection, the grass collection basket
(5) must be cleaned after use.
10.2
Mowing with the mulching insert
When mulching, the cuttings are shredded in the closed
lawnmower housing and then dispersed on the lawn.
Grass collection and disposal are not required. The fine
green waste falls back into the grass root as a natural
fertiliser, adds moisture to the lawn and supplies it with
important nutrients.
www.scheppach.com
Level indicator (3) on the grass
collection basket (5) (Fig. 13)
Emptying the grass collection
basket (5) (Fig. 9, 13, 14)
GB | 33
Publicidad
