Publicidad
Idiomas disponibles
Idiomas disponibles
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
11.1
Cleaning
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure. We recommend
that you clean the product directly after every use.
• Ventilation openings must always be free.
• Cleaning with a garden hose is only recommended
at low pressure. A high-pressure cleaner is not suit-
able for cleaning the lawnmower.
1. Unhook the grass collection basket and brush it out
with a hand brush. You can also roughly clean the
housing of the lawnmower with the sweeper.
2. Clean the underside of the lawnmower with a spatu-
la and hand brush. The spatula helps to remove
coarse and larger plant debris from the area of the
blade (19). Cleaning the underbody is easier and
more thorough immediately after use. Then dirt and
plant residues are still fresh and can be loosened
more easily.
3. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interi-
or.
4. Check that the grass ejection is clear of grass resi-
dues and remove these if necessary.
11.2
Maintenance
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
11.2.1
WARNING
There is a risk of injury if you work with a
damaged blade.
–
Wear protective gloves!
–
For safety reasons you should only ever have
your blade sharpened and balanced by an autho-
rised specialist workshop. For optimum results it
is recommended that the blade should be inspect-
ed once a year.
–
When changing the blade, only use original spare
parts.
1. Hold the blade (16) tightly with one hand.
2. Turn the blade screw (15) anticlockwise using a
13 mm open-ended spanner (not included in the
scope of delivery).
3. Remove the blade screw (15) and the washer.
4. Re-install the new blade (16) in reverse order. Fas-
ten the blade screw (15) properly. Ensure that the
blade (16) is correctly positioned in the fastening
pins and lies flush.
5. The tightening torque of the blade screw (15) is
45Nm. Also replace the blade screw (15) when re-
placing the blade (16).
11.2.2
If the blade (16) has come into contact with an obsta-
cle:
• Switch off the motor, wait for it to stop, remove the
battery and pull out the safety key.
• Check the blade (16) for damage.
• Damaged or bent blades (16) must be replaced.
• Never attempt to bend a bent blade (16) back to
straight again.
• Never mow the lawn with a bent or heavily worn
blade (16) as this will cause vibrations and can lead
to further damage to the lawnmower.
www.scheppach.com
Changing the blade (16) (Fig. 19)
Damaged blade (16) (Fig. 19)
GB | 35
Publicidad
