Publicidad
Idiomas disponibles
Idiomas disponibles
The noise and vibration values have been determined
through a standardised measurement process.
Noise data
Sound pressure L
pA
Sound power L
wA
Measurement uncertainty K
Vibration parameters
Vibration a
h
Measurement uncertainty K
The total vibration emission values specified and the
device emissions values specified have been measured
in accordance with a standardised test procedure and
can be used for comparison of one electric tool with an-
other.
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
WARNING
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under a
load).
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
90.0 dB
• With accessories as well as wearing parts and re-
78.5 dB
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
2.08 dB
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
2
< 2.5 m/s
2
1.5 m/s
8
Assembly
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered
tool is ready for use.
CAUTION
Danger of injury due to rotating blade. Only work on
the product when the blade is switched off and sta-
tionary!
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Ensure that the cable is not squeezed during assem-
bly.
8.1
Installation of the lower push bar
(4) (Fig. 1, 3, 4)
Note:
Make sure that the teeth mesh.
1. Attach the lower push bar (4) to the pre-fitted
screws.
2. Screw down the lower push bar (4) with one washer
(4a) and one quick-clamp lever (4b) on each side.
Ensure that the cable (10), which will later be at-
tached with a cable clip (9), is not in the way.
3. Lock the two quick-clamp levers (4b) by pressing
them in the direction of the lower push bar (4).
They must rest against the lower push bar (4) in
such a way that they can be tightened with moder-
ate force.
Otherwise, the quick-clamp levers (4b) must be
turned clockwise to tighten them or anti-clockwise to
loosen them.
www.scheppach.com
GB | 31
Publicidad
