Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE
Mulching is only possible on relatively short lawns.
10.2.1
Inserting the mulching insert (13)
(Fig. 13, 15, 16)
1. Lift the discharge flap (8).
2. Remove the grass collection basket (5) (if used) by
the carrying handle (5a).
3. Lift the discharge flap (8) and insert the mulching in-
sert (13).
4. Adjust the cutting height (see 9.1).
Note:
Cut the grass back by 2 cm if the grass is 4-6 cm high.
10.2.2
Difference between lawn mowing
and lawn mulching (Fig. 13, 16)
When using the mulching insert (13), the grass clip-
pings are not collected in a grass collection bag, but
shredded and distributed over the lawn. The nutrients
contained in the grass clippings are thus broken down
by soil organisms forming a nutrient cycle. Mulched
lawns therefore need to be fertilised much less fre-
quently.
As a general rule, the lawn must be mowed relatively
often so that only small amounts of mulch remain on
the lawn. It is therefore best to mulch the lawn at least
once a week and set the mower so that only approx.
40% of the total height of the lawn is mulched. If the
mulch remains visible on the lawn (e.g. during the first
cut of the year or during heavy growth), the grass bag
(5) should be used.
10.3
Safety key (14) (Fig. 1, 17)
Note:
The product can only be started if the security key is in-
serted in the product.
1. Open the cover (7).
2. Insert the rechargeable batteries (17) as described
in 9.2.
3. Insert the safety key (14).
4. Close the cover (7).
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait
for it to stop, remove the battery and pull out the safe-
ty key.
10.4
Blade-stop device (Fig. 1, 18)
Before each use, you must check the blade stop de-
vice. Start the motor as described in 10.5.
1. Release the safety bar (1). The engine switches off
and the blade (16) is braked.
34 | GB
2. The blade (16) must stop within 7 seconds.
10.5
Switching the product on/off (Fig.
18)
Note:
The charge status of the battery is indicated by the cor-
responding LED light lighting up.
Low
High
Switching on
1. Hold the on/off button (11) depressed and pull the
safety bar (1) rearwards.
Switching off
1. Release the safety bar (1).
2. Pull out the safety key (14).
3. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until
the product has come to a complete stop.
10.6
Auto/Eco mode (Fig. 1)
The product automatically starts up in the last mode
used.
1. You can switch between Auto/Eco mode by press-
ing the Auto/Eco switch (12).
Auto mode:
The product adjusts the motor speed to suit the load.
Eco mode:
The product runs at the lowest speed for maximum run-
time.
10.7
After mowing
• Check all screws and nuts before the next use.
Tighten up loose screws.
• Empty the grass collection basket before the next
use.
• Please also observe the chapter "Storage".
www.scheppach.com
Low battery charge status
High battery charge status
Publicidad
