A3 Troubleshooting; A4 Disposal Of Bravomatic - Acqua Brevetti BravoMATIC Manual De Instrucciones

A3 TROUBLESHOOTING
Anomaly
Upon water delivery
request, water pressure
drops considerably
The filter does not react
when buttons are pressed
ALARM flashing message on
the display alternating with
the interior lighting
The filter keeps performing
backwashing procedures
-
Leakage of water from the
filter drain
A4 DISPOSAL OF BRAVOMATIC
This product falls within the scope of the Directive 2012/19 / EU concerning the management of electrical and
electronic equipment (WEEE).
Electrical and electronic devices must not be considered household waste.
Consumers must return electrical and electronic devices at the end of their useful life to suitable centers
recycling.
Inquire through the municipal authority for the location of ecological platforms to receive the product for disposal and
its recycling. For any further information, contact the manufacturer.
The crossed-out wheeled bin symbol indicates that the product is subject to the disposal regulations established by
Regulations (RAEE). The illegal disposal of the product by the user involves the application of the
administrative sanctions. With the recycling and re-use of the material and other forms of use of obsolete devices we
can make an important contribution to the protection of the environment.
The equipment is not potentially dangerous for human health and the environment, it does not contain harmful
substances as per Directive 2011/65 / EC (RoHs), but if abandoned in the environment impacts negatively on the
ecosystem.
BravoMATIC - ENGLISH
Cause
Filtering element dirty
Voltage interrupted
Power supply unit defective
Electric circuit not working
The filter is out of order
If present: differential switch
blocked
The drain valve is out of phase
Visit the website www.acquabrevetti.it
for the list of TSCs closer to you.
MAN139 PAGE E-13
Solution
Perform a manual backwashing
Check the power supply
Replace the power supply unit
Replace the electrical circuit
Set the equipment to the by-pass
mode
-
Disconnect and connect again the
filter power supply in order to
reset the alarms
If necessary, contact the service
center.
Contact the service center
Contact the service center