Haier BrewMaster Instrucciones De Instalación página 10

InstaJJing the GuardraiJ
Follow the stepsbdow to install theguardraiJon
theworktoF
1. Placethe guardraiJon top of the cabinet.
2. Align aJJ holesof the guardrd with the hales
of the cabinet.
3. Secure the guardraiJ to the cabinet with eight
smdJ Phillips-Head screws.
Installing the ¢02 Regulator and ¢O2 Cylinder
Follow the stepsbdow to safely install the CO2 regulator and CO2 cyJinden You
mustread and understandthe following proceduresfor CO2 cylinders before
installation.
Note: Your CO2 cylinder is shipped empty to avoid any possibleaccidentsduring
transportation_ When you purchasethe first keg of beer,haveyour beer
distributor fill the CO2 cylinder.
1. Installthe CO2air line hoseto the regulator by attachingone end of the red air
line hoseto the hosebarb connectionon the
CO2 reguJatonSecurethe hoseby using one
of the two self-lockingblack plastic snap-on
damps. Use pliers to snap the damp on C°nnec4t°theC°2Cy[inder
tightly to ensurethat there are no Jeaks.
2. Attach the CO2 regulator to theCO2
cylinder by screwing the regulator nut onto
thecylinder valve and tightening with an
adjustable wrench.
Clamp (
3. Removethe nut from the retainer bolt. Shut-Off
Valve
Usetwo retainer fixing screwsto securethe
retainer to the holeson the back of the
0 ........
_o_heCO
cyJinder_ Air L in_
4_ Slide the cylinder through the retainer and
place it in the cabinet. Thentighten the
retainer nut.
Retaine_
CO2 Cylinder