Publicidad
Idiomas disponibles
Idiomas disponibles
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiUi
_i__i__i__i__i__i__i__i__i__i__i__i__i__i__i__i__i__i__i__i_
In,taJJing
the CJeaning
Kit
Readand understandthe following instructionsbefore installing the cleaning kit.
1. Mix one gallon of warm water and one ounce (one
tablespoon) of cleaner in a bucket.
Note:
Do not use lye, soap or
hot
water.
2.
Remove the cleaner cap. Fill the jar and replace the cap.
'_
Leave the remaining solution in the bucket.
3.
Turn off either the air cock on the regulator or the valve on
the C02 tank_
4.
Disconnect the tap from the barrel Then disconnect the beer line from the tap
by turning the nut counter-clockwise. Place the tap and the end of the hose in
the bucket.
5.
Remove the faucet from the tower with the wrench and attach the fitting on the
cleaning bottle in its place.
Note:
Make sure there is a washer in the back of the fitting_
6.
Hold the cleaning iar upside down until the solution runs through to the bucket
as shown in the above figure.
7.
FiJJthe iar with cod clean water and repeat the process until the water runs
clea[L
8.
Rinse the tap in the bucket with cool water.
9.
Remove the fitting from the tower and replace the fauceL Make sure the washer
is in the back of the fauceL
10. Re-attach the beer hose to the tap and attach the tap to the barrel
Not÷: Beer lines shouldbe flushed after each keg is emptid.
15
Publicidad
