Haier BrewMaster Instrucciones De Instalación página 9

Assembly str cti@ s
ReadcarefulJyand understandaJJinstallationinstructionsbefore installing the beer
dispensenHf a fter completingthe processyou are still unsurewhether the beer
dispenserhas been properly installed,we recommendthat you contacta qualified
installer.
installing the Casters
Follow the stepsbdow to install thecasters.
Nut
\
\
1. Emptythe insideof the cabinet completely
and
Jaythe beer dispenserdown sideways.\'Ve
recommendthat you place a piece of
cardboard or cloth underneaththe cabinet to
preventdents or scratchesto the cabineL
Caster
2. hsert the casters into the holes on the boffom corners
of
the cabinet. Tighten
each caster by turning the nutcJockwise with the
wrench
provided,
3. Once all four castershave been tightened evenly,stand the cabinet in an upright
position.
installing the Beer Tap
Follow the stepsbdow to install the beer tap.
1_First, removethe cabinet plug located on the
worktop_Firmlygrasp the cabinet plug, twist
and pull upward_
Note: Store this plug in a safe place as it wiJJ
be required when converting the beer
dispenserinto a refrigeraton
2. Placethe gasketover thewing nut on the
bottomof the beer tap_
3. Passthe beer tube through the gasketto the
baseof the beer tap.
4_ Pushboth the wing nut and the beer duct
through the hole in the worktop until the beer
tap is resting on top of the cabinet.
Handle
Draft Arm Assembly
Small Phillips Head
Guard Rai_
5. Align the holesof the beer tap with thegasket and pilot holeson the worktop of
cabinet.
6. Secure the beer tap to the cabinet by inserting four large Phillips-Head screws
into the holes and tightening,