Vortice 10912 Manual De Instrucciones página 53

ENGLISH
Maintenance and cleaning
Make sure that the product is disconnected from the mains before starting any operations.
Note: Open the front door as indicated in fig.14 to access the filter area.
Filters
Recommended maintenance timetable: In general the level of
air pollution depends on the geographical installation
area, and therefore filter duration is variable. With these
considerations in mind, the maintenance times for filters can
however be set as follows:
Filter inspection: every 50/60 days
Filter replacement: after 3,9 or 12 months (depending on
which was set during installation by the installer). A pre-alarm
signal, which warns the user that filter replacement is
necessary, will appear on the display. Filters must be replaced
within 2 months from this signal. The saturated filter alarm
will be activated at the end of this time. The counter will also
be reset when an error is reset (described in the paragraph on
"Alarm menu display").
Note: Failure to clean or replace filters causes serious problems for system efficiency, including:
- Increase in pressure losses in the air circuit and reduction of air flow;
- Consequent decrease in machine yield and worsening of comfort in the environment
Note: Saturated filters are the most common cause of device blocking.
Filter extraction: fig.15
15 15
Heat exchanger
Checking and any cleaning of the exchanger must be carried out by professionally qualified personnel, preferably every 3
years. For cleaning, use a vacuum cleaner; for the H models the enthalpy exchanger can be cleaned using lukewarm water,
not at high pressure, and a detergent; rinse well after washing.
14 14
3
1
2
53