GE WSLP1500 Manual Del Propietario E Instalación página 16

Installation Instructions
WASHER CONNECTIONS - STATIONARY MODEL WSLS1500
%
INSTALLATION CH ECKLIST
Before starting the washer, check to make sure:
klain power is turned on.
CI The washer is plugged in.
CI The water faucets are turned on,
CI The unit is level.
CI The drain hose is properly tied up.
CI There are no leaks at the faucet, drain line
or washer.
I-_ RUN THE WASHER THROUGH A
COMPLETE CYCLE
Checkfor water leaks and proper operation.
i81 REMOVE THE PROTECTIVE FILM
COVERING THE CONTROL PANEL
i_ READ THE REST OF THIS OWNER'S
MANUAL
It contains valuable and helpful information that will
save you time and money.
OWNERS
MANUAL
NOTE: If your washer does not operate, please
review the Before You Call For Service section.
ALCOVE OR CLOSET INSTALLATION
If your washer is approved for installation in an alcove or
closet, there will be a label on the back of the machine
describing requirements.
. Minimum clearances between washer and adjacent
walls or other surfaces are: !" either side, 2" front,
4" rear.
. Minimum vertical space from washer to overhead
shelves, cabinets, ceilings, etc. is 24:'
. Closet doors must be Iouvered or otherwise ventilated
and have at least 60 square inches open area for
washer only, or if the closet contains both a washer
and dryer, doors must contain at least 120 square
inches of open area equally distributed.
NOTE:The clearances stated on this label are minimums.
Consideration must be given to providing adequate
clearances for installation and servicing.
O
Closet door
$
60 sq.in.
(387.1sq.crn)
60 sq. in.
(387.1sq.cm)
16