Publicidad
Idiomas disponibles
Idiomas disponibles
Do not use any accessories that
b)
have not been provided or
recommended by the manufacturer
for this power tool. Just because you
can attach the accessories to your power
tool, does not ensure they are safe to use .
The permissible speed of the
c)
accessory tool used must be at
least as high as the maximum
speed specified for the power
tool. Accessories that rotate faster than
the permissible rate can break and throw
pieces into the air .
The external diameter and
d)
thickness of the accessory tool
used must comply with the
dimensions of the power tool.
Incorrectly dimensioned accessory tools
cannot be sufficiently shielded or controlled .
Grinding discs, sanding drums or
e)
other accessories must match the
grinding spindle or collet chuck of
your power tool exactly. Accessory
tools which do not fit precisely into the take-
up of the power tool will rotate unevenly,
vibrate severely and can lead to a loss of
control .
Discs, grinding cylinders, cutting
f)
tools or other accessories mounted
on a mandrel must be completely
inserted in the collet or chuck. Any
"protrusion" or exposed parts of
the mandrel between the grinding
tool and the collet or chuck must be
kept to a minimum. If the mandrel is
not sufficiently tightened or the grinding tool
protrudes too far, the tool could come loose
and been thrown out at high speed .
30 GB/IE
Never use damaged accessory
g)
tools. Before each use, check
accessory tools such as grinding
discs for chips or cracks, sanding
drums for cracks, wearing or
excessive wear and tear and wire
brushes for loose or broken wires.
If the power tool or the accessory
tool in use is dropped, check to
see if it is damaged or use an
undamaged accessory tool. When
you have checked and inserted the
accessory tool, ensure that you
and any other people in the vicinity
remain outside of the range of the
rotating accessory tool and allow
the tool to rotate at maximum
speed for one minute. Damaged
accessory tools usually break during this
test period .
Wear personal protective
h)
equipment. Depending on the
application, ensure that you use
full face protection, eye protection
or goggles. If required, use a dust
mask, ear protectors, protective
gloves or special apron to protect
you from grindings and material
particles. Eyes should be protected
from flying debris that may be generated
during certain applications . Dust or filter
masks must filter any dust created by the
application . If you are exposed to loud
noise for any length of time, you may suffer
hearing loss .
Ensure that other people remain at
i)
a safe distance to your workspace.
Anyone who enters the workspace
must wear personal protective
equipment. Fragments of the workpiece
or broken accessory tools can fly off and
cause injury – even outside the immediate
working area .
Publicidad
