Publicidad
Idiomas disponibles
Idiomas disponibles
In the event of a leakage of batteries/
rechargeable batteries, immediately remove
them from the product to prevent damage .
Remove batteries/rechargeable batteries
if the product will not be used for a longer
period .
Risk of damage of the product
Only use the specified type of battery/
rechargeable battery!
Insert batteries/rechargeable batteries
according to polarity marks (+) and (–) on
the battery/rechargeable battery and the
product .
Use a dry lint-free cloth or cotton swab
to clean the contacts on the battery/
rechargeable battery and in the battery
compartment before inserting!
Remove exhausted batteries/rechargeable
batteries from the product immediately .
˜ Appliance-specific safety
instructions for transformers
Only for indoor use!
m
WARNING!
Dusts from materials such as leaded paint,
u
some types of wood and metal can be
harmful to your health .
Contact with or inhalation of these dusts
u
can represent a health hazard for the
person operating the appliance and other
people in the vicinity .
Wear safety goggles and a protective
u
dust mask!
Safety transformer fail-safe
Thermal link
34 GB/IE
˜ Operation
NOTE
Never use the product for other purposes
u
and only original parts/accessories . Using
attachments or accessory tools other than
those recommended in the user manual
can lead to a risk of injury .
˜ Changing the battery
Switch off the LED light
o
Remove the three screws from the battery
o
compartment cover at the rear of the grip
ring with LED light
Replace the used batteries in the product
o
with new batteries of the same type (button
cell LR41) . Note polarity when installing
new batteries .
Close the battery compartment . Secure the
o
battery compartment with the three screws .
˜ Changing and inserting the
tool/mandrel/collet chuck
(Fig . F)
NOTE
Extending the length of mandrel
u
not allowed on this product . Insert the
mandrel
as deep as possible into the
[
13 ]
collet chuck
.
18 ]
[
Press and hold the spindle lock
o
Rotate the tensioning nut
o
clicks into place .
Use the combination key
o
tensioning nut
[
5 ]
Remove any attached tool .
o
Push the intended tool/mandrel through the
o
tensioning nut
.
[
5 ]
Insert the tool/mandrel into the appropriate
o
collet chuck
for the tool shaft .
18 ]
[
Press and hold the spindle lock
o
Push the collet chuck
o
insert .
.
6 ]
[
.
6 ]
[
is
13 ]
[
.
[
7 ]
until the lock
5 ]
[
to undo the
[
23 ]
from the thread .
.
7 ]
[
into the thread
[
18 ]
Publicidad
