Publicidad
Idiomas disponibles
Idiomas disponibles
Tips and tricks
If you exert too much pressure, the fi tted tool
o
can break and/or the workpiece could be
damaged .
Move the tool over the workpiece at a
o
steady speed and while exerting light
pressure, to achieve optimum working
results .
Hold the product fi rmly with both hands,
o
when carrying out cutting work .
Observe the data and the information in the
o
table to prevent the end of the spindle from
touching the perforated base of the grinding
tool .
Place the product on the cradle
o
product is not in use .
Secure the workpiece with a clamping
o
device or vice instead of holding it in your
hands .
˜ Cleaning and maintenance
˜ Cleaning
m
WARNING! RISK OF INJURY!
Switch off the product before carrying out
u
any cleaning or maintenance work .
The product is maintenance-free .
Use a dry cloth to remove all dirt from the
product .
Do not allow any liquids to get into the
product .
m
WARNING!
Have the product repaired by the Service
u
centre or a qualifi ed electrician and only
using genuine replacement parts . This will
ensure that the safety of the product is
maintained .
Always ensure that the power plug or
u
the mains cable is replaced only by the
manufacturer of the product or by an
approved customer service provider . This
will ensure that the safety of the product is
maintained .
m
WARNING!
If the external connection cable of this
u
transformer is damaged, it must be
replaced by the manufacturer or its
customer service or a similarly qualifi ed
person in order to avoid a hazard .
˜ Storage
Use the metal clip
o
on a wall tool holder .
Store the product and the accessories in the
o
plastic case .
Store the product and the accessories in a
while the
o
9 ]
[
dry indoor location protected from direct
sunlight .
˜ Transportation
Transport the product in the plastic case .
o
Protect the product from any heavy impact
o
or strong vibrations which may occur during
transportation in vehicles .
Secure the product to prevent it from slipping
o
or falling over .
˜ Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities .
Product:
to hang the product
[
3 ]
Observe the marking of the packaging
materials for waste separation, which
are marked with abbreviations (a)
and numbers (b) with following
meaning: 1–7: plastics/20–22: paper
and fi breboard/80–98: composite
materials .
GB/IE
37
Publicidad
