WIRING FOR OUTPUT
Marine 3004A 4-channel output (4ohm/2ohm)
+
Front left speaker
L
+
EN
Front right speaker
Marine 3004A 3-channel output (Font: 4ohm/2ohm;
Rear: 4ohm)
+
-
Front left speaker
FRONT
L
R
BRIDGED
+
-
Front right speaker
Marine 3004A 2-channel output (4ohm)
+
-
Subwoofer
FRONT
L
BRIDGED
Marine 7005A 5-channel output (4ohm/2ohm)
+
-
Front left speaker
FRONT
REAR
L
R
L
BRIDGED
BRIDGED
+
-
Front right speaker
-
+
-
Rear right speaker
FRONT
REAR
R
L
R
-
+
-
Rear left speaker
REAR
L
R
BRIDGED
+ -
Subwoofer
REAR
R
L
R
BRIDGED
+ -
Subwoofer
+
-
Rear right speaker
SUB
R
+ -
+
-
Subwoofer
Rear left speaker
CONNECTING THE REMOTE BASS
CONTROLLER (MARINE 7005A ONLY)
SETTING GAIN, CROSSOVERS, AND BASS
BOOST
Setting the gain
1. Start with
and the crossover control rotated midway.
2. For the front and rear channels, choose
music you're familiar with. For the
subwoofer channel on the Marine 7005A,
MAX
choose music with substantial bass
GAIN
content.
MIN
3. Turn the volume control on your receiver to
¾ of its total output.
4. Adjust the
listening carefully to the bass output. If
you hear distortion, turn the
counterclockwise to decrease the gain.
Selecting the crossover mode
On the front and rear channels, you can select
your preferred crossover mode.
Choose
above a certain point to reach your speakers.
Recommended if you're using a subwoofer in
your system, as it keeps low base from your
HPF
full-range speakers.
X-OVER
FULL
Choose
a certain point to reach your speakers.
LPF
Recommended if you're bridging the front or
rear channels to power a subwoofer.
Choose
your speakers. Recommended if you're not
using a subwoofer in your system.
Note: The crossover mode for the subwoofer
channel of the Marine 7005A is low-pass only.
Selecting the crossover frequency
Choose the crossover point to suit listening
preferences. Turn the dials to the left to lower
320Hz
the crossover point and to the right to raise
FREQ
32Hz
the crossover point. Exact crossover settings
for coaxial speakers and subwoofers depend
on your listening preferences.
REMOTE
CONTROL
control set to minimum,
control clockwise,
control
to allow only frequencies
to allow only frequencies below
to allow all frequencies to reach