Harman Infinity Marine 3004A Manual Del Propietário página 5

Selecting the subwoofer phase
0°
(Marine 7005A only)
PHASE
Switch the
determine which setting provides the most
180°
clean bass output.
Selecting the bass boost
(Marine 7005A only)
12dB
BASS
BOOST
Adjust the
0dB
counterclockwise to suit your taste.
SPECIFICATIONS
Marine 3004A
Power output @
75 watts RMS x 4
4 ohms (14.4V)
Power output @
55 watts RMS x 4
4 ohms (12V)
Power output @
100 watts RMS x 4
2 ohms (14.4V)
Power output @
80 watts RMS x 4
2 ohms (12V)
Power output in
200 watts RMS x
bridged mode
2 at 4 ohms
(14.4V)
Power output in 160 watts RMS x
bridged mode (12V) 2 at 4 ohms
Frequency response 10-40 K Hz
Crossover 32-320 Hz variable,
frequencies 12 dB/ octave
Line-level input 200 mVrms –
sensitivity 4 Vrms
High-level input
1 – 22Vrms
sensitivity
Signal-to-noise ratio >80 dB
THD+N @ rated
power
Fuse rating
12-5/8" x 2-3/16" x
Dimensions
7-1/8" (320 mm x
(W x H x D)
55.7 mm x 180 mm)
Weight 3.15 kg
Recommended wire
gauge
Maximum operation
temperature:
back and forth to
control clockwise or
Marine 7005A
50 watts RMS x 4,
320 watts x 1
40 watts RMS x 4,
255 watts x 1
75 watts RMS x 4,
500 watts x 1
65 watts RMS x 4,
390 watts x 1
150 watts RMS x
2 at 4 ohms
130 watts RMS x
2 at 4 ohms
10-40 KHz /
25-320 Hz
32-320 Hz variable
high- and low-pass
(front and rear);
32-320 Hz low-
pass (subwoofer);
12 dB/octave
200 mVrms –
4 Vrms
1 – 22Vrms
>80 dB
<1% <1%
30 x 2 30 x 3
14-3/16" x 2-3/16" x
7-1/8" (360 mm x
56 mm x 180 mm)
4.02 kg
8 4
45°C 45°C
TROUBLESHOOTING
No audio and POWER INDICATOR is off.
• No voltage at BATT+ and/or REM terminals, or bad or no
ground connection. Check voltages at amplifier terminals with
VOM.
No audio and PROTECT INDICATOR flashes every
4 seconds.
• DC voltage on amplifier output. Amplifier may need service; see
enclosed warranty card for service information.
No audio and PROTECT and POWER INDICATORS flash.
• Voltage less than 9V on BATT+ connection. Check boat
charging system.
No audio and PROTECT INDICATOR is on.
• Amplifier is overheated. Make sure amplifier cooling is not
blocked at mounting location. Or, there may be voltage greater
than 16V (or less than 8.5V) on BATT+ connection. Check boat
charging system.
Amplifier fuse keeps blowing.
• The wiring is connected incorrectly or there is a short circuit.
Check wiring connections.
Distorted audio.
• Gain is not set properly. Check setting. Check wires for shorts
or grounds. Amplifier or source unit may be defective.
Distorted audio and PROTECT INDICATOR flashes.
• Short circuit in speaker or wire. Remove speaker leads one at
a time to locate shorted speaker or wire, and repair.
Music lacks dynamics or "punch".
• Speakers are not connected properly. Check speaker
connections for proper polarity.
Engine noise—whining or clicking—in system when the
engine is on.
• Amplifier is picking up alternator noise. First, check ground
connection on the amplifier – a loose or improper ground is
one of the main causes for noise. Turn down gain. Move RCA
audio cables away from power wires. Installing an alternator
noise filter on power line between battery and alternator might
also be necessary.
EN