Publicidad
CLOCK SET UP
(AUTO / MANUAL)
Set the clock accurately for proper automatic timer
recording. If the Public Broadcasting Station (PBS) is
available in your area, follow "AUTO CLOCK
SETTING". If it is not, follow "MANUAL CLOCK
SETTING".
AVTO CLOCK SETTING
You can have the TVA'^CR set the clock automatically
by using the Public Broadcasting Station (PBS) channel
in your area. Once you have set the clock by using the
following procedure, the TVA^CR will automatically
monitor the correct time and date being broadcast by the
PBS station in your area, using a new service called
Extended Data Service (XDS).
Make sure
...
• Use the remote control for this procedure.
• TVA^CR power must be turned on.
• Confirm that the antenna connections are correct.
• The cable converter box must be turned on if your
TVA^CR is connected directly to it. (See NOTES:)
• The channel is properly set in advance. (See page 13.)
NOTES:
• Auto clock setting only needs to be set once. But it
can be done again if the clock's time has become
incorrect for some reason.
• If the TVA^CR is connected directly to a cable
converter box or satellite box, the local PBS station
must be selected on the cable box itself, and the
TVA^CR must be set to the output channel of the
cable converter box or satellite box
(usually channel 3 or 4), to be able to set up or correct
the clock automatically.
If you do not know what your local PBS station is,
then follow "Manual Clock Settings" on page 15.
The TVA^CR cannot control the channels of the
cable converter box or satellite box.
1
Select "SETTING CLOCK"
Press the MENU button.
Press the PLAY/A or STOP/T
button to point to "SETTING
CLOCK".
Then, press the F.FWDy^ button.
2 Set "AUTO CLOCK" to
[ON]
Press the F.FWD/^ or REW/-^
button repeatedly until [ON]
appears.
3
Enter the channel number for the PBS station
Press the PLAY/A or STOP/T
button to point to "AUTO
CLOCK CH".
Then press the F.FWD/^ or
REW/-^ button until the channel
number for your local PBS
station appears.
If you do not know the PBS channel number, leave it set
to [AUTO] which is located before [2]. The TV/VCR will
search automatically all available channels for the local
PBS station, and will select that channel.
4
Exit the Auto Clock Setting
Press the MENU button to return to TV mode.
5
Turn off the TVA/CR
Turn the TV/VCR off. Because the Auto Clock func¬
tions automatically while the TV/V CR is off.
If you choose [AUTO],
•
the TV/VCR must search until the PBS channel is
found. It must scan each channel for a couple of sec¬
onds to determine if that channel is transmitting the
XDS signal.
• if the time, that is automatically set by this selected
PBS station is incorrect, it may not be your local PBS
station, but one from a different time zone. Or there
is a case that no channel is broadcasting the XDS
signal in your area, as shown by no time. In these
cases, you must manually enter the correct local PBS
station, or set the clock manually and turn off the
Auto Clock Setting feature.
-
14
-
EN
8H30
Publicidad
