Publicidad
Idiomas disponibles
Idiomas disponibles
GB
10.5 Aligning the appliance
The appliance should be placed on a flat and solid
surface.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately
bumping on the diagonals. The slightly swaying
should be the same in both directions. Otherwise
the frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the door.
10.6 Fine tuning of the doors
If the doors are not in one level, this mismatch can be
remedied by following.
10.6.1 Using adjustable foot
Rotate the adjustable foot according to the direction
of arrow i(Fig. 10.6 -1) to turn up or down the foot.
10.6.2 Using spacers
Open the upper door and lift it.
Carefully clip the spacer (enclosed in the
accessory bag) in the white plastic ring of the
middle hinge by hand or using tools like pliers (Fig.
10.6-2). Do not scratch or bruise the door.
Notice: Levelling
In the future use of refrigerator, doors uneven phenomenon may occur to the weight of
stored food. Then please adjust according to the above methods.
10- Installation
33
Publicidad
