Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
WINDOW KIT ASSEMBLY
Step one: prepare the window sliders
1. Measure the window opening where the
window kit will be installed.
NOTE: Window kit length range 48cm ~ 160cm
(19" ~ 63")
2. Assemble as many sliders as necessary to fit
the window. If the window opening is less than
the minimum length of a single slider, use the
slider that has the hole in it and cut it to the
correct length. Make sure not to cut the end
that has the hole as this is necessary to attach
the exhaust hose adapter.
3. Use the window slider bolts to secure the
window sliders at the correct length.
EXHAUST HOSE
Pull out the hose
1. Rotate the exhaust hose gently backwards.
2. Pull out the exhaust hose.
INSTALLING THE WINDOW KIT
The instructions below can be used for a hung
window application (shown on the left) or an
optional sliding window application (shown on the
right).
1. Cut foam seals to the correct lengths and
attach them to position A and B on the window
frame as shown below.
B
A
2. Insert the window slider kit into the window
opening and close the window the secure it in
place.
3. Cut the foam pad to match the window kit and
attach it to position C as shown to decrease
heat loss.
11
B
A
Publicidad
