Bosch VitaPower 4 Serie Manual De Usuario página 24

en Operation
17
Blade insert with chopping and
grinding blade
1
Depending on the appliance specifica-
tions
Symbols
You can find an overview of the symbols
used on your appliance here.
Symbol Explanation
Position markings
Open locking mechanism.
Close locking mechanism.
Rotary switch
The rotary switch is used to start and stop
processing and select the speed.
Symbol Description
Switch off the appliance.
Switch on the appliance.
Lowest speed: Blending food
that should not be cut up too
small.
Highest speed: Blending,
puréeing, emulsifying, frothing
and cutting up food.
Instantaneous switching (pulse
function): Highest speed as
long as the rotary switch is
held in this position.
Tip: You can adjust the speed steplessly
between and
Safety systems
Start lock-out
Start lock-out prevents your appliance from
being switched on accidentally.
You can switch on and operate the appli-
ance once the blender jug has been cor-
rectly positioned and the lid is locked.
Overload protection
The overload protection system prevents
the motor and other components from be-
ing damaged through being overloaded.
24
⁠ .
Ope r a t i o n
Operation
Ope r a t i o n
General information
Please bear this information in mind so that
you can get the best out of your appliance.
¡ Observe the recommended quantities,
settings, processing times and other in-
formation.
→ "Application examples", Page 25
¡ Fill the blender jug and the To-Go
blender jug in the following order: li-
quids, seeds and nuts, fresh fruit and ve-
getables, leaf vegetables, frozen fruit and
vegetables, ice.
¡ Before blending in the blender jug, cut
the ingredients into cubes approx. 2 cm
in size. For the To-Go blender jug or the
chopper, cut into cubes of approx. 1 cm.
¡ Use instantaneous switching to blend in-
gredients only briefly or in intervals.
Setting up the appliance
1. Place the appliance on a stable, level,
clean and flat work surface.
Adjust the power cable to the required
2.
length.
– To shorten the cord, push it into the
cord storage compartment.
– To lengthen the cord again, pull it out
of the cord storage compartment.
3. Do not insert the mains plug.
Preparing the blender jug
Notes
¡ Check the seal on the EasyClick blade
insert. If a seal has been removed, rein-
sert it correctly.
¡ The seal remains on the EasyClick blade
insert for cleaning. If the seal is dam-
aged or not correctly positioned, liquid
may run out.
→ Fig. 2 - 4
Processing food using the blender
jug
5 10
→ Fig. -
Adding more ingredients
→ Fig. 11 - 14