OHAUS FC570+R05 Manual De Instrucciones página 19

TM
Frontier Centrifuge FC5707 EN-13
All changed settings must be confirmed by the key "Start"(10). The word "Store"(2) appears in the
display "RPM/RCF"(A-1) - Only then the pre-selections are valid!
A-1
10
2
Figure. 28
4.2 Signal turn on / off
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "L" with the adjusting dial (4). As a
result, the words "On Sound" appears in the display "RPM/RCF" (A-1). If you press the key "RPM/RCF" (5) now,
the word "On" flashes and you can switch off the sound with the adjusting dial (4) (See figure 29).
After you have stored the settings (See 4.1) you change back to the normal program mode again by switching off
the centrifuge for a short while.
A-2
A-1
4
5
6
Figure. 29
4.3 Volume pre-selection of sound signal
Proceed as described under point 4.1.2 to enter this program mode and then press the key "Accel/Decel" (6). In
the display "Acc/Dec" (A-2) the word "Service" flashes. Now select the letter "U" with the adjusting dial (4). As a
result, in the display "RPM/RCF" (A-1) the words "Vol=0- 9/Sound" appear. After pressing the key "RPM/RCF"
(5), you can adjust the desired volume between 0 (low) and 9 (high) with the adjusting dial (4) (See figure 30).
After you have stored the settings (see 4.1) you can change back to the normal program mode again by switching
off the centrifuge for a short period.