OHAUS FC570+R05 Manual De Instrucciones página 21

TM
Frontier Centrifuge FC5707
A-1
5
6
4.6 Sleep Mode On / Off
After not using the centrifuge for 5 minutes, the display automatically switches off. By pressing any botton, it
switches on again. Proceed as illustrated, to enter this program mode, press the key, "accel/decel" (6). In the
display, "accel/decel" (A-2) flashes the word, "service". Select the letter "I" with the adjusting dial (4). As a result,
appearing in the display, "rpm/rcf" (A-1), the word "SLEEP". After pressing the key, "rpm/rcf" (5), turn the sleep
mode function (On) or (Off), with the adjusting dial (4).
After the settings have been stored by user, the normal program mode can be changed back again by switching off
the centrifuge, for a short period.
4.7 Call up operating data
ATTENTION:
This should only be performed by advance user or service engineer.
In the mode "Basic Adjustments" you can call up the operating data of the centrifuge. Please proceed as
described under point 4.1 to enter this program mode. Press the key "Accel/Decel" (6). In the display "Acc/Dec"
(A-2) the word "Service" flashes.
With the adjusting dial (4) various information can be called up:
A= previous starts of the centrifuge
H= previous operating hours
S= software version
r= converter software
E= list of previous error messages
h= running time of the motor
The list of the last 99 error messages can accessed by pressing the key "RPM/RCF" (5). Scroll through the list by
using the adjusting dial (4). The respective error codes appear in the display "RPM/RCF" (A-1). Please refer to
"Table 4: error messages" (see APPENDIX).
A-2
Figure. 32
EN-15
4