Cleaning The Shuttle Race; Cleaning The Shuttle Area; Replacing Shuttle Assembly - Sears Kenmore 385.12912 Manual De Instrucciones

Cleaning the Shutlle Race
This area must be kept free of dust, lint and
occasional tangled thread Clean the shuttle race area
about every three months.
o Cleaning the shuttle area
(_ Bobbin case
(_) Levers
Q Shuttle race cover
(_) Shuttle
(_ Shuttle race
(_}') Center pin on the shuttle
Q Shuttle driver
Pointed hook
0 (Oil here)
1- Raise the needle bar to its highest point and remove the
bobbin case (_,
2 Push shuttle race levers (_ aside Lift shuttle race
cover (_Dand take shuttle @ out
3, Clean the shuttle race Owith a lint brush
4, Put a drop of oil on the center pin of the shuttle (_) and
shuttle race 0 Do not over oil
o Replacing shuttle assembly
0 Bobbin case
(_) Levers
(_ Shuttle race cover
0 Shuttle
(_) Shuttle race
(_) Center pin on the shuttle
(Z) Shuttle driver
Pointed hook
@ (Oil here)
1 Position shuttle race (_) as illustrated so that shuttle
driver (Z) is forming half moon on the left side of the
machine
2, Hold shuttle (_ by center pin (_ and position shuttle so as
to form a half moon on the right side The pointed hook(_
will be on the bottom
3 Place shuttle race cover (_) into place over shuttle
assembly
4., Snap the levers (_) back into the original position
0
®
64