Worx WX100 Serie Manual Original página 18

variationson how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use ofthe correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
EN
also take account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
18
running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
4.INTENDED USE
WX100 WX100.X WX108 WX108.X
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and plastic.
WX370 WX370.X WT375 WT375.X
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling inwood, metal
and plastic.
5.OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing & Installing the battery pack
Charging the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when changing
accessories. Always ensure the bit is secure before starting
the tool. Damage to the Chuck or a loose bit may cause
possible personal injury.
--Removing the bits
FIGURE
See Fig. A1
See Fig. A2,
See Fig. B1