AEG STS 350 Instrucciones De Manejo página 9

ENGLISH
General View:
Fig. 1 +2
ad) Clamping Screw for Saw Blade
2) Saw Bar
3) Supporting Roller
4) Saw Dust Blower
6) Electronic Regulator (for STSE 350 only)
Technical Data:
Power input
Power output
Height of stroke
Idle load strokes (str/min)
Max. cutting depth 90°
Max. cutting depth 45°
Bevel (Diagonal) cuts up to
Electronic control
Electrical two-speed switch
Weight
Max. cutting capicity:
Hard and soft wood: 45 mm
Resopal-coated chip boards: 30 mm
Laminated fabric: 30 mm
Plastics 20 mm
Nonferrous metals: 3m
Steel: 2m
Connection:
Machines can be connected to single-phase
AC only. They are protected according to class
II VDE 0740 and CEE 20 and can therefore be
connected to outlets without an earth connec-
tion.
Before putting the machine into operation,
make sure that the mains voltage corresponds
with operating voltage on machine name
plates.
Scope of Delivery:
STS-350:
Tool with 2 hex screw drivers 3 mm and 5 mm,
1 saw blade.
STSZ 350 and STSE 350:
Tool with 2 hex screw drivers 3 mm and 5 mm,
5 different saw blades in container.
© Mains Switch with Locking Button
2 Clamping Screw for Saw Bench
& Saw Table
(9) Electrical two-speed switch (for STSZ 350
only)
STS 350 STSZ 350 SISE 350
350 W 350 W 350 W
190 W 190 W 185 W
18 mm 18 mm 18 mm
2.700 2.900 and 300 to
3.200 2.700
45 mm 45 mm 45 mm
26 mm 26 mm
45° 45° 45°
= - yes
at yes ad
1,75 kg 1,75 kg 1,8 kg
Accessories:
Circle cutter, for circle dia. from 90 to 460 mm,
parallel stop, for strip width from 45 to 230 mm,
fret saw auxiliary table ZT-ST, for stationary use
of fret saws. |
Scroll work equipment LSA, for stationary
scroll work on saw table ZT-ST.
Sheet metal carrying case.
The pertinent order numbers for accessories
are shown in our catalogues.
General Safety and Operating
Instructions:
1. Prior to working on fret saw itself, pull plug
out of socket.
2. Make sure that base plate rests reliably on
work when sawing.
3. Lubricate cutting line when sawing metals.
4. For additional support of saw blade, make
sure that saw blade rests against supporting
roller.
5. When sawing sheet metal less than 1mm
thick include a wooden shim approx. 5 mm
thick placed under sheet metal into sawing cut.