Beha-Amprobe AT-6000-EUR Serie Guía Rápida De Inicio página 7

Special Application: Finding Shorts
Set-up:
1
Transmitter
Verify the
Loop LED
is ON.
1. Connect the Transmitter with the test leads
to the circuit.
2. Hold down the HIGH button for two
seconds to activate Loop mode.
Wire tracing mode:
Tracing a cable to find shorts
1. Start tracing the cable until the signal stops.
2. Verify the place of the fault: move the
Transmitter to the other end of the wire and
repeat tracing from the opposite end. If the
signal stops at the exact same location the
fault has been located.
AT-6000-TE
TRANSMITTER
HI
LO
AT-6000-TE
TRANSMITTER
HI
LO
©2019 Beha-Amprobe
®
Advanced Wire Tracer Series - Quick Guide
Set-up:
2
Receiver
Precision
tracing
mode
1. Turn on the Receiver
2. Press the MODE button to select a
wire tracing mode (either Quick Scan or
Precision Tracing).
Note: This method will be affected
by signal cancellation effect. Expect
a relatively weak signal.
For detailed specifications and ordering go to beha-amprobe.com 6011095 A
88
NCV
AT-6000-RE
5