Beha-Amprobe AT-6000-EUR Serie Guía Rápida De Inicio página 8

AT-6000-EUR
Special Applications: Finding Breaks
Set-up:
1
Transmitter
Transmitter
indicator
showing signal
in HIGH mode
1. Ensure the wire is De-energized.
2. Connect the Transmitter with the test leads
to the circuit.
3. Select HIGH signal mode by pressing HI.
Precision tracing mode:
Tracing a cable to find
breaks or opens
6
Beha-Amprobe
®
AT-6000-TE
TRANSMITTER
HI
LO
Note:
De-energized wires that run in
parallel with the black test lead.
Set-up:
2
Receiver
Precision
tracing
mode
1. Turn on the Receiver.
2. Press the MODE button until the Precision
Tracing function is selected.
1. Start tracing the cable until the
signal stops.
2. Verify the place of the fault:
move the Transmitter to the other
end of the wire and repeat tracing
from the opposite end. If the signal
stops at the exact same location the
fault has been located.
Note:
by signal cancellation effect. Expect
a relatively weak signal.
For best results, ground all
88
NCV
AT-6000-RE
This method will be affected