Orbegozo FDR 33 Manual De Instrucciones página 14

FDR 18 / FDR 33
Maintenance
The electric fryer does not require special maintenance, but the following precautions should be
taken:
- Do not leave the appliance running unsupervised; the oil will decrease and heating the resistor
and sensor without oil may render them inoperative for future uses.
- Oil may spontaneously catch fire if the temperature surpasses 300ºC, so you should never leave it
running at maximum temperature.
- When using more than one fryer, make sure that there is enough space between them to
circulate hot air, since they may deform due to the heat.
- Only use the original baskets; forcing the basket into the oil container may create a risk upon
removing it when finished.
- If you do not use the fryer for long periods of time, we recommend applying a thin layer of oil
over the complete surface, even on the resistor and sensor.
- Do not use margarine, butter or lard. They are not suitable for frying since they emit smoke at
low temperatures.
- If overheated, the safety system turns the device off. In order to restart it, unplug the unit and
wait until it cools. Once cooled, re-plug it in and press the "RESTART" button on the back of the
heating unit. To do so you will need a thin and long tool.
Cleaning
- Always unplug the fryer before cleaning.
- Never start cleaning until the oil has cooled down.
Fryer body/ bowl
Fryer outer body – wipe with a damp cloth and dry thoroughly. Never put it in water.
•
Inner bowl – after each use, fill with hot soapy water and soak for 20 minutes. Then use a
•
non-abrasive cleaner.
Basket
After each use, remove and soak in hot soapy water for 20 minutes. Then use a stiff brush.
•
The lid and basket can alternatively be washed in your dishwasher.
•
SERVICE AND CUSTOMER CARE
If you experience any problems with the operation of the fryer, before calling for assistance refer to
the troubleshooting guide.
TROUBLESHOOTING GUIDE
Problem Possible cause
Fryer does not Fryer not plugged in
work
Fuse blown
Solution
Check fryer is plugged in
Check the fuse/circuit breaker
for your installation and replace
the fuse if necessary. If this does
14