Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The Speed Control Lever can be set to obtain speeds 1, 3, 5, 7 and 9 if a finer
adjustment is required. To move the Speed Control Lever with ease, lift up slightly as you move
it across the settings in either direction.
IMPORTANT: Do not exceed Speed 2 when preparing yeast doughs as this may cause
damage to the Stand Mixer.
PRODUCT ASSEMBLY
1.
Turn the Stand Mixer off (0) and unplug.
2.
Unlock and lift the Motor Head. Then, lock the head to keep it lifted.
3.
Place the Bowl on the Clamping Plate and twist clockwise (right) to lock in place.
4.
Slide the accessory over the shaft, aligning with the pin, then rotate clockwise (right) to
hook it over the pin on the shaft.
5.
Unlock the Motor Head and move it down. Then, lock the head to keep it down. Before
mixing, test lock by attempting to raise the Motor Head.
(OPTIONAL) To adjust Beater to Bowl Clearance: Tilt back and lock the Motor Head.
Locate the screw revealed under the Motor Head. Turn the screw slightly counterclockwise
(left) to raise beater, or clockwise (right) to lower it.
NOTE: If you overadjust the screw, the Locking Lever may not lock into place.
PRODUCT USAGE
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
1.
Plug it into a grounded 3 prong outlet. Start with lower speed to avoid splashing, and
increase speed gradually. Refer to the "Speed Control Guide" section.
Unplug mixer before touching beaters.
Failure to do so can result in broken bones, cuts, or bruises.
2.
Do not scrape the Bowl while operating. Scraping the Bowl once or twice during mixing is
usually sufficient.
PRODUCT DISASSEMBLY
1.
Turn the Stand Mixer off (0) and unplug.
2.
Unlock and lift the Motor Head. Then, lock the head to keep it lifted.
6
WARNING
Electrical Shock Hazard
WARNING
Injury Hazard
Publicidad
