Descargar Imprimir esta página

Parkside PDSSAP 20-Li C3 Traduccion Del Manual De Instrucciones Originale página 29

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
1 ≙ no-load rotation speed: 0–1900
−1
min
/impact rate: 0-1200 min
torque: 120 Nm
2 ≙ no-load rotation speed: 0-2400
−1
min
/impact rate: 0-2400 min
torque: 150 Nm
3 ≙ no-load rotation speed: 0-3050
−1
min
/impact rate: 0-3800 min
torque: 190 Nm
4 ≙ no-load rotation speed: 0-3600
−1
min
/impact rate: 0-4300 min
torque: 226 Nm
1 2 3 4 ≙ speed/impact/torque rate
is set in the PARKSIDE App (Expert
Mode).
• Direction of rotation switch (3)
NOTICE! Only operate the direction
of rotation switch when the tool has
stopped!
The arrow on the direction switch (3) in-
dicates the working direction.
Screw in screw/nut
• Centre Switch lock
Unscrew screw/nut
• On/Off switch (15)
• After inserting the battery: Connect-
ing to the PARKSIDE app
• Switching on: Press
• Infinitely variable speed regula-
tion: The more you press the on/off
switch, the higher the speed.
• Switching off: Release
• "Connected" indicator (5)
Status of the connection with the
PARKSIDE app
flashing connection attempt
continuous light connection estab-
lished
Attaching and removing the
attachment tool
−1
/
Notes
• Tool holder: ¼" (6.35 mm) hexagon
−1
/
drive
• Attachment tool: Screw bit/Bit recept-
acle/Socket/Socket adapter (not in-
−1
/
cluded)
• Directional data viewed from behind.
Attaching the attachment tool
−1
/
(Fig. B)
1. Unlock tool holder (1): Slide the lock-
ing sleeve (2) forward.
2. Insert the bit holder (18) or socket ad-
apter (19) into the tool holder (1).
3. Clamp attachment tool: Release the
locking sleeve (2).
4. Slide the desired screw bit/socket onto
the bit holder (18/socket adapter
(19).
5. Check that the attachment tool is firmly
secure by pulling on it.
Removing the attachment tool
(Fig. B)
1. Unlock tool holder (1): Slide the lock-
ing sleeve (2) forward.
 CAUTION! Risk of burn injury! At-
2.
tachment tools can become very hot.
Wear protective gloves whenever ap-
propriate.
Remove the attachment tool.
Checking the battery charge
level
LEDs
red, orange, green Battery charged
red, orange
red
GB
MT
Meaning
Battery partially
charged
Battery needs to be
charged
29

Publicidad

loading