Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
the warm engine can cause burn
damage to the grass. To prevent burn
damage , to the grass, always stop the
engine when you stop the product on
grass areas.
1. Push down on the brake pedal (A) fully until the
product stops fully.
2. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 14 .
3. Put the throttle control in the slow position and
let the engine operate at idle speed for some
minutes.
4. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
5. Turn the ignition key to the "STOP" position and
remove the ignition key from the ignition.
To use the throttle control
The throttle control adjusts the engine speed and the
speed of the blades in the cutting deck.
A
14
The exhaust gas from
A
To engage
B
•
Put the throttle control in the fast position (A) to
operate the engine at full speed. Always have the
throttle control in the fast position when you cut
grass.
•
Put the throttle control in the slow position (B) to
operate the engine at idle speed.
To use the cruise control
Only use the cruise control for forward travel on
smooth, straight surfaces. The cruise control will
disengage automatically if the conditions for cruise
control become unsatisfactory.
1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
2. Pull the cruise control lever (A) up and hold it
while you release the forward drive pedal.
3. Release the cruise control lever to engage the
cruise control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
To use the headlight
•
Push the power switch to position (A) to make
the headlight come on.
B
•
Push the power switch to position (B) to make
the headlight go off.
To engage and disengage the
cutting deck
WARNING:
cutting deck without a deflector or grass
catcher installed to the grass discharge.
The product has an operator presence control
(OPC). When you go away from the seat with the
engine on and the cutting deck engaged, the engine
stops.
B
A
Do not operate the
2161 - 001 - 22.06.2023
Publicidad
