Publicidad
Idiomas disponibles
Idiomas disponibles
Safety instructions for operation
Personal protective equipment
WARNING:
instructions that follow before you use
the product.
•
Use approved personal protective equipment
when you use the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident
does occur. Let your dealer help you select the
right equipment.
•
Use approved hearing protection. Long-term
exposure to noise can result in permanent
hearing impairment.
•
Use heavy-duty slip-resistant boots or shoes.
Steel toes are recommended. Do not use open
shoes or go with bare feet.
•
Use protective gloves when necessary, for
example when you attach, examine or clean the
cutting equipment.
•
Do not wear loose-fitting clothing, jewelry or
other items that can get caught in moving parts.
•
Keep first aid equipment and fire extinguisher
near.
Safety devices on the product
WARNING:
instructions that follow before you use
the product.
•
Do not use a product with safety devices that
are damaged or do not operate correctly. Do a
check of the safety devices regularly. If the safety
devices are damaged, speak to your Husqvarna
service agent.
•
Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective
devices are not attached or are damaged.
To do a check of the operator presence control
(OPC)
WARNING:
product with an operator presence
control (OPC) that does not operate
2161 - 001 - 22.06.2023
Read the warning
Read the warning
Do not operate the
correctly. If the OPC does not operate
correctly, repair it immediately. Speak to
an approved service agent.
•
Make sure that the engine cannot start unless
the brake pedal is pushed down fully and the
cutting deck is disengaged.
•
Make sure that the engine stops when the
operator goes away from the seat when the
parking brake is disengaged.
•
Make sure that the engine stops when the
operator goes away from the seat when the
cutting deck is engaged.
•
Make sure that the clutch control for the cutting
deck cannot operate when the operator is away
from the seat.
To do a check of the reverse operation system
(ROS)
If the reverse operation system does not operate
correctly, repair the product immediately. Speak to
an approved service agent.
1. Start the product. Refer to
page 12 .
2. Engage the cutting deck. Refer to
disengage the cutting deck on page 14 .
3. Make sure that the engine stops when you try to
reverse with the ignition key is in the on position
(A).
A
4. Start the product and engage the cutting deck
again.
5. Turn the ignition switch to the ROS on position
(B).
6. Make sure that the engine does not stop when
you reverse with the ignition key in the ROS on
position.
To do a check of the brake
WARNING:
necessary if the product uses more than
5 ft (1.5 m) to stop at the highest
speed in the highest gear on a level, dry
surface.
1. Park the product on a level, dry concrete or
paved surface. Push the brake pedal down fully
and engage the parking brake.
To start the product on
To engage and
B
Brake maintenance is
7
Publicidad
