Publicidad
Idiomas disponibles
Idiomas disponibles
8. Attach the front link (L).
I
a) Start from the left side of the product.
b) Put the rod end that has a thread for the
link assembly through the front hole in the
suspension bracket (I).
c) Put the flared ends of the front link (L) into
the slots in the front mower bracket (K).
d) Install the washer and the retainer spring (J).
9. Examine the front height compared to the rear
height. If an adjustment is necessary, refer to
adjust the parallelism of the cutting deck on page
24 .
10. Install the mower drive belt onto the clutch pulley.
A
CAUTION:
drive belt for correct routing in all
mower pulley grooves.
11. Set the mower deck lift lever to the highest
position.
12. If it is necessary, adjust the gauge wheels before
you operate the mower. Refer to
anti-scalp rollers on page 26 .
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right
and left side of the product, the cutting height can
be adjusted. Adjust the cutting height on the side of
cutting deck that has the lower cutting height.
1. Make sure that the tires are fully inflated.
24
L
J
K
Do a check of the
To adjust the
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
Note:
Each full turn of lift adjustment nut
changes the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to
lower the cutting deck.
b) Turn the lift adjustment nut (A) to the right to
lift the cutting deck.
5. Cut some grass and examine the results. Adjust
if it is necessary.
To
To do a precision side to side adjustment of the
cutting deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
5. Measure the distance (B) from the bottom edge
of the blade to the ground on the left and right
side.
B
Note:
The distance must be the same on the 2
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Note:
Each full turn of the lift adjustment nut
changes the cutting height with 3/16 in (4.7 mm).
A
WARNING:
The blades on the
cutting deck are sharp and can
cause injury. Use protective gloves.
2161 - 001 - 22.06.2023
B
Publicidad
