RIDGID K-400AF Instrucciones De Uso página 3

K-400, K-3800, K-750, K-7500
tool from an obstruction. The cable is strongest when used in clockwise
direction. Cable may kink or break when used in reverse direction.
let motor stop completely and tighten screw on
the drum. If you are using the autofeed push the lever in neutral position.
Continue manually until the tool is free.
Autofeed adjustment
Removing the cable (K-400, 0)
Installing cable
drum and E clip.
Retighten the screw to clamp the cable against the back wall of the drum.
Installing replacement cable – K-750, K-7500
Retrieve end of cable from centre hole in carton. Connect to pigtail and check
Attaching tools
Maintenance
Drain cable drum after each use.
Use sharp tools.
Replace worn or kinked cables.
Clean and grease all exposed moving parts.
lightweight machine oil.
For all other service and maintenance take machine to a RIDGID authorized
service center.
2
Ridge Tool Company