Publicidad
Idiomas disponibles
Idiomas disponibles
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
4) Wear dust mask.
5) Use appropriate detectors to determine
if utility lines are hidden in the work
area or call the local utility company for
assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage.
6) Switch off the power tool immediately
when the tool insert jams. Be prepared
for high reaction torque that can cause
kickback.
The tool insert jams when:
-
the power tool is subject to overload or
-
it becomes wedged in the workpiece.
7) When working with the machine,
always hold it firmly with both hands
and provide for a secure stance.
The power tool is guided more secure with both
hands.
8) Secure the workpiece.
A workpiece clamped with clamping devices or in
a vice is held more secure than by hand.
9) Always wait until the machine has come
to a complete stop before placing it
down.
The tool insert can jam and lead to loss of control
over the power tool.
a) Only for GB Market : Your product is fitted with an
BS 1363/A approved electric plug with internal
fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it
should be off cut and an appropriate plug fitted in
its place by an authorised customer service agent.
The replacement plug should have the same fuse
rating as the original plug.
The severed plug must be disposed of to avoid
a possible shock hazard and should never be
inserted into a mains socket elsewhere.
14
b) Only for AUS and NZ Market : Use a residual
current device (RCD) with a rated residual current
of 30 mA or less.
10) The use of any accessory or
attachment, other than those
recommended in the instruction manual,
may present a risk of personal injury.
Additional Safety Warnings
1) Do not insert wires or other similar
objects into the ventilation slots.
You can be killed by an electric shock or injured
seriously.
2) Accessories may be hot after prolonged
use.
When removing the bit from the tool avoid contact
with skin and use proper protective gloves when
grasping the bit or accessory.
3) Do not let familiarity gained from
frequent use of tools allow you to
become complacent and ignore tool
safety principles.
A careless action can cause severe injury within a
fraction of a second.
4) Keep handles and grasping surfaces
dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not
allow for safe handling and control of the tool in
unexpected situations.
Check before Use
1. Connection to Power Supply
(See figure 2)
2. Extension Cord
110-127 V∼
Nominal cross
Max.
section of
length
conductor
0.75 mm
20 m
2
1.0 mm
30 m
2
1.5 mm
45 m
2
Use an extension cord if the distance to the power
source requires its use. Extension cord must be of
appropriate thickness and length for the supply
220-240 V∼
Nominal cross
Max.
section of
length
conductor
0.75 mm
45 m
2
1.0 mm
60 m
2
1.5 mm
90 m
2
Publicidad
