Publicidad
Idiomas disponibles
Idiomas disponibles
of electric current. Too thin or too long cord will
cause voltage to drop reducing the motor power.
Use it as short as possible.
3. The Switch
Warning
When you plug in the power supply with the
tool switched on, sudden rotation of tool may
result in accident.
Check to see that switch lever returns to its original
position after pulling or pushing it.
4. The Power Source
Observe correct main voltage. The voltage
of power source must agree with the voltage
specified in the name plate.
Warning
When you use the tool for 110V in
220V/230V, the speed of the motor will be
increased abnormally. In result, the drill bit
and the tool may be damaged or motor can
be damaged by a fire.
5. Mains Outlet
When inserting the plug, if a sound is heard or
if it a taken out easily you must repair it. Please
contact nearby electric shop.
When you use the mains outlet as it is, it causes
the accident by overheating.
6. Work place
• Check work place considering cautions.
• Do not use the product where there is a fire
hazard.
• Prevent dust accumulation at the workplace.
• Dusts can easily ignite.
• Dusts from materials such lead-containing
coatings, minerals and metal can be harmful to
one's health.
• Contact with or inhaling the dusts can trigger
allergic reactions to the operator or bystanders
and/or lead to respiratory infections.
• Certain metal dusts are considered hazardous,
especially in conjunction with alloys such as zinc,
aluminium or chromium.
• Materials containing asbestos may only be
worked by specialists.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class
respirator.
• Observe the relevant regulations in your country
for the materials to be worked.
7. Trial run
Before starting the work, wear protection
(goggles, safety helmet, ear plugs, protective
gloves) and run the tool in the direction
avoiding other persons to see if the tool is
operated normally.
8. An explanation of any symbols or
pictograms on the tool relevant to safe
use
Wear ear plugs
Return waste material
V
Volt
A
Amperes
W
Watts
∼
Alternating current
Environmental Protection
Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly
recycling.
The plastic components are labeled for categorized
recycling.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Guide Lines 2012/19/
EC for waste electric and electronic equipment and its
implementation into national law, power tools that are
no longer usable must be collected separately and
Do not dispose of batteries
with general refuse
n
No load Speed
0
Hz
Hertz
Revolutions or recip-
/min
rocations per minute
Class II construction
15
Publicidad
